HP StorageWorks XP Remote Web Console Software - Manual (Page 29)

Java Runtime Environment
(Note 1) Web Browser Operating System
RTE 5.0.07 (1.5.0_07) Mozilla 1.7.12_00
HP-UX 11.0
HP-UX 11.11
RTE 5.0.07 (1.5.0_07) Mozilla 1.7.13
HP-UX 11.31
RTE 5.0.07 (1.5.0_07) Firefox 2.0
JRE 5.0 Update 11 (1.5.0_11) Mozilla 1.4
Red Hat Enterprise Linux AS Ver2.1
Red Hat Enterprise Linux AS Ver4.0
Notes:
1: Use the JRE provided by Sun Microsystems Inc.
2: When the SVP supports IPv6, specify IPv6 addresses.
Setting Up Remote Web Console
Your HP service representative installs the SVP software and LAN cabling. You need to document the
serial numbers (SNs) and IP addresses of each storage system, because these numbers are required
for Remote Web Console operations.
NOTE:
It is important to verify that you have a unique IP address for each SVP, to avoid any conflicts. If a
conflict occurs, determine the SVP IP addresses of all connected storage systems, and obtain a unique
IP address for the desired storage system. You can also contact HP technical support for assistance
in assigning IP addresses.
Configuring the Web Browser
To connect to the desired storage system SVP and use the Remote Web Console Java application, a
web browser is required on the Remote Web Console computer. How to configure a web browser
may differ depending on the version of the OS and web browser. For details on how to configure
your web browser, see your web browser's manual.
CAUTION:
Do not access any unreliable websites from your Remote Web Console computer.
To configure your web browser:
1. Make sure that the Remote Web Console computer is connected to a network via a LAN.
CAUTION:
Using a modem for network connections is not supported.
XP24000/XP20000 Remote Web Console User's Guide 29