Configuring communications over only ipv6, Temporary files settings dialog box (for jre 6.0), Figure – HP StorageWorks XP Remote Web Console Software User Manual
Page 34
Figure 6 Temporary Files Settings Dialog Box (for JRE 6.0)
Configuring Communications over only IPv6
Internet Protocol Version 6 (IPv6) can also be used for communications between a Remote Web
Console computer and an SVP. To communicate with only IPv6, both a Remote Web Console computer
and an SVP must be configured to use only IPv6 for communications. For information on how to
configure an SVP, contact HP Technical Support (see “
NOTE:
To use IPv4 and IPv6 for communications, do not apply the setting described in this section. In this
case, IPv4 has a priority over IPv6.
This section explains how to configure a Remote Web Console computer when its operating system
is Windows Vista or Solaris 10. For other operating systems, contact the appropriate developers.
For Windows Vista: To configure a computer to use only IPv6 for communications:
1.
Select the Windows Control Panel > Network and Sharing Center > Manage Network Connections.
2.
Select and right-click a network that connects an SVP, and click Properties in the pop-up menu.
3.
Click Continue if the User Account Control dialog box appears.
The Networking dialog box displays properties of the selected network (see
4.
Clear the Internet Protocol Version 4 (TCP/IPv4) check box in the list.
5.
Click OK to close the dialog box.
Installation Requirements and Procedures
34