HP StorageWorks XP Remote Web Console Software - Manual (Page 86)

Figure 34 Syslog Window
The Syslog window has the following features:
Description Item
You can specify whether to transfer the audit log to the primary syslog server. To
transfer the audit log, select Enable. To not transfer the audit log, select Disable. Output to Primary
Server:
You can set an IP address and a port number for the primary syslog server. Once you
set Output to Primary Server to Enable, IP and Port become available. For both IP
and Port, the defaults have been entered, so change them as needed.
For IP address set either IPv4 or IPv6. If your SVP is Windows XP, only IPv4 address
is available.
• To set an IPv4 address, select IPv4. For IP, enter four integers in the range of 0 to
255. For example, enter
nnn . nnn . nnn . nnn , where n is a number. Only enter
numbers. Do not enter the intervening periods.
• To set an IPv6 address, select IPv6. For IP, enter eight hexadecimal numbers in
the range of 0 to FFFF. For example, enter
hhhh : hhhh : hhhh : hhhh : hhhh : hhhh : hh-
hh : hhhh , where h is a hexadecimal number. Do not enter the intervening colons.
• For Port, enter one integer in the range of 1 to 65,535.
Primary Server Set-
ting:
You can specify whether to transfer the audit log to the secondary syslog server. To
transfer the audit log, select Enable. To not transfer the audit log, select Disable. Output to Secondary
Server:
Using the Remote Web Console GUI 86