HP StorageWorks XP Remote Web Console Software - Manual (Page 78)

Port Status Window
The Port Status window displays the port information using the image of the ports mounted on the
storage system.
To open the Port Status window, log in to the Remote Web Console, and then select Go, System
Information and Port Status from the menu bar of the Remote Web Console main window. Storage
partition administrators cannot display the Port Status window.
Figure 29 Port Status Window
Cluster-1 and Cluster-2 in the Port Status window indicate the clusters. The ports of Cluster-1 are listed
on the upper part, and the ports of Cluster-2 are listed on the lower part of the Port Status window.
Each cluster has up to 16 PCBs (Printed Circuit Board) and the name of each PCB is displayed on the
header of the port list. The icons show the port name, port LED status, and equipment information for
the port. The icons displayed indicate the following information:
•
: This port is equipped and currently used. The cable is properly set. This port is available
for the operation.
•
: This port is equipped and available for the operation.
•
: This port is not equipped or not available.
Alerts Window
The Alerts window displays the internal status (according to the SIM information reported to the host)
of the connected storage system. The storage system generates a service information message (SIM)
whenever it detects an error or service requirement.
Using the Remote Web Console GUI 78