HP XP7 Storage - Manual (Page 125)

The following example shows how to display information about the audit
log settings:
PROMPT>dlnkmgr -l view -sys -audlog
Audit Log : off
Audit Log Category : -
KAPL01001-I The HDLM command completed normally. Operation name
= view, completion time = yyyy/mm/dd hh:mm:ss
PROMPT>
Example 5
The following example shows how to display the value of the display-of-
the-physical-storage-system-information setting:
PROMPT>dlnkmgr -l view -sys -pstv
Physical Storage View : off
KAPL01001-I The HDLM command completed normally. Operation name
= view, completion time = yyyy/mm/dd hh:mm:ss
PROMPT>
To display path information
When displaying path information, if you specify either the -item or -c
parameter and also specify the -path parameter, you can select the items to
display and display a summary of path information. This section describes
each parameter, path information and displayed items.
To display path information
-path
When you specify the -path parameter and do not specify either the -c or
-item parameter, the information will be displayed about the HDLM
managed paths without abbreviating or selecting items.
In the sub-parameters (following -path), you can filter the paths to be
listed using -hdev and sort the list using -srt. When you omit both
parameters, the command displays information for all the paths in order
of increasing AutoPATH_IDs.
For details on what is displayed in each item, see
Table 6-10 Path
Information on page 6-40 .
AutoPATH_IDs displayed by the -path parameter depend on the sequence
in which HDLM detects the paths after a host is started up. Because of
this, make sure that you use the path name PathName to identify a path.
The sub-parameters are as follows:
-pstv|-vstv
If the -pstv parameter is specified, information about the physical
storage system is displayed. If the -vstv parameter is specified,
information about the storage system recognized by the operating
system is displayed. If neither parameter is specified, information is
Command Reference
6-33
Hitachi Dynamic Link Manager (for VMware®) User Guide