HP XP7 Storage - Manual (Page 72)

Audit Log : on(6)
Audit Log Category : all
KAPL01001-I The HDLM command completed normally. Operation name =
view, completion time = yyyy/mm/dd hh:mm:ss
PROMPT>
Setting Up Integrated Traces
When you use HDLM, the activity logs of the HDLM command are output to
the integrated trace information file(program-installation-destination-drive:
\Program Files
#
\HITACHI\HNTRLib2\spool\hntr2n.log(where n indicates a
file number)) of the Hitachi Network Objectplaza Trace Library (HNTRLib2)
installed on the remote management client.
#
For Windows 7 (x64) , Windows Server 2008, and Windows Vista (x64),
Program Files is Program Files (x86).
If a lot of integrated trace information is output, the older information might
end up getting deleted in a very short amount of time. Also, if a large amount
of integrated trace information is suddenly all output at the same time, any
integrated trace information that is overflowing the buffer might not be saved
into the integrated trace files. To save as much information as possible,
change the settings for Hitachi Network Objectplaza Trace Library, increasing
the integrated trace file size and buffer size. Note that if the values are too
large, it will place a heavy load on the system. When determining these
values, be sure to consider these operational tradeoffs.
The following table shows the default and recommended values for the
integrated trace file settings.
Table 3-7 Default and Recommended Values for the Integrated Trace File
Settings
Setting Default value
Recommended
value
Integrated trace file size 256 (KB) 4096 (KB)
Number of integrated trace files 4 8
Buffer size per
monitoring
interval
Monitoring cycle 10 (seconds) 5 (seconds)
Buffer size per
monitoring interval
64 (KB) 256 (KB)
Number of
messages to be
output per
monitoring
interval
Monitoring cycle 0 (seconds) 0 (seconds)
Number of messages
to be output
0 0
If Hitachi Network Objectplaza Trace Library (HNTRLib2) is already installed,
the existing settings will be inherited. If you change these settings, keep in
mind that programs other than HDLM also use them. If an earlier Hitachi
3-20
Creating an HDLM Environment
Hitachi Dynamic Link Manager (for VMware®) User Guide