HP XP7 Storage - Manual (Page 143)

Product S/N LUs iLU HDevName Paths
OnlinePaths
SANRISE_AMS 77010152 1 0191 t10.HITACHI_770101520191
2 2
KAPL01001-I The HDLM command completed normally. Operation
name = view, completion time = yyyy/mm/dd hh:mm:ss
PROMPT>
Items of LU information
Table 6-14 LU Information on page 6-51 describes the displayed LU
information. The following explains the table headings:
• No summary displayed: The user specifies the -lu parameter.
• Summary displayed: The user specifies the -lu -c parameter.
Table 6-14 LU Information
Displayed item
Description
No summary
displayed
Summary
displayed
Product Model ID of the storage system
SerialNumber S/N Serial number of the storage system
LUs Total number of LUs managed by HDLM among
the LUs in the storage system
Dynamic I/O Path
Control - The setting information about the dynamic I/O
path control function is displayed for each
storage system.
on: The dynamic I/O path control function is
enabled.
off: The dynamic I/O path control function is
disabled.
-: The dynamic I/O path control function is not
supported.
If an LU whose settings differ from the settings
based on the system storage unit is included, *
is added after the on or off being displayed.
iLU LU number in the storage system.
This number combined with the storage system
name (shown in DskName) identifies the LU that
is accessed by a path.
•
For P9500 and XP7, indicated by a
hexadecimal number. The first two
characters of iLU are 00, the middle two
numbers are the CU number, and the last
two characters are the internal LU number
within the CU.
Command Reference
6-51
Hitachi Dynamic Link Manager (for VMware®) User Guide