HP Designjet Z6100 Printer series - Manual (Page 54)

12
. Carefully insert the loop-shaping core.
NOTE: Make sure that you insert the loop-shaping core. The take-up reel will not function
correctly without it. The loop-shaping core must have end caps. Make sure that the end caps
extend over the edges of the paper.
13
. Use the wind-direction switch on the take-up reel motor to select the winding direction. Setting 1
winds the paper so that the printed image faces in. Setting 2 winds the paper so that the printed
image faces out.
The front panel shows you to the correct setting based on the winding-direction decision you made
in step 7.
14
. Press the OK button on the front panel. The Take-up reel has been successfully installed
message appears.
15
. The following image shows how the printer looks when it is operating. As paper is fed from the
printer, it drops down in a loop and then up into the take-up reel spindle.
NOTE: While the take-up reel is operating, make sure that the take-up reel sensors are not
blocked.
NOTE: The automatic paper-cutter is disabled when the take-up reel is in use.
42 Chapter 4 Handle the paper
Handle the paper