HP Designjet Z6100 Printer series - Manual (Page 80)

2
. Open the carriage interconnect wiper.
3
. Load the sponge by positioning the sponge on the face of the carriage interconnect wiper with the
shorter tab in the locating slot.
4
. Close the carriage interconnect wiper, trapping the sponge in place.
5
. Open the printhead carriage latch and extract the printhead that is causing the problem, as indicated
on the front panel. See Remove a printhead on page 61 .
68 Chapter 5 Handle the ink system
Ha
nd
le the
ink sys
tem