HP Designjet Z6100 Printer series - Manual (Page 76)

10
. The front-panel display identifies the missing printhead.
Insert a printhead
1
. If the printhead is new, shake it vigorously before removing the protective caps. Hold the printhead
upright (with the protective caps facing down) and shake the printhead vigorously in a smooth up
and down motion for about 15 seconds.
NOTE: Be careful not to strike the printhead against anything while shaking it, because this
could cause damage.
2
. Remove the orange protective caps by pulling them down.
3
. The printhead is designed to prevent you from accidentally inserting it into the wrong slot. Check
that the colored label on the printhead matches the colored label of the carriage slot into which the
printhead is to be inserted.
64 Chapter 5 Handle the ink system
Ha
nd
le the
ink sys
tem