HP 3PAR Remote Copy Software User Manual
Page 103
3.41
Initial Synchronization Using Tape Backup
InForm OS Version 2.3.1
Remote Copy User’s Guide
7
Create a synchronous Remote Copy group on InServ1:
◆
<group_name>
is the name of the created Remote Copy group (for example
sync_group_1).
◆
<target_name>
is the Remote Copy target (for example InServ2).
◆
<mode>
is either synchronous (sync) or periodic (for example sync).
8
Admit the volume to the Remote Copy volume group:
◆
<VV_name>
is the name of the virtual volume added to the Remote Copy group (for
example localvv.0 and localvv.1).
◆
<group_name>
is the name of the Remote Copy volume group (for example
sync_group_1).
◆
<target_name>
is the name of the Remote Copy target system on which the backup
volume for
<VV_name>
resides (for example InServ2).
◆
<sec_VV_name>
is the name of the backup volume created for
<VV_name>
(for
example remotevv.0 and remotevv.1).
Repeat the
admitrcopyvv
step for each volume that will be part of the group:
9
Activate Remote Copy for the Remote Copy volume group created on InServ1:
◆
-nosync
indicates that an initial synchronization of the specified group is not
performed and the group’s virtual volumes are set to synchronized state.
◆
<group_name>
is the name of the started Remote Copy volume group (for example
sync_group_1).
On InServ1:
# creatercopygroup <group_name> <target_name>:<mode>
On InServ1:
# admitrcopyvv VV_name group_name target_name:sec_VV_name
On InServ1:
# startrcopygroup -nosync <group_name>