HP 3PAR Remote Copy Software - Manual (Page 196)

B.60 showrcopy
Remote Copy User’s Guide InForm OS Version 2.3.1
In the example above:
■ Name . The name of the group.
■ Target . The target to which the group is mirrored.
■ Status . The following values can appear in the group Status field:
◆ New . Group that has not yet been started.
◆ Starting . Currently attempting to start the group.
◆ Started . Group is started (has Remote Copy running).
◆ Stopped . Group was stopped.
■ Role . The role of the group as either Primary or Secondary.
■ Mode . The mode of the group as either Periodic or Synchronous.
■ Options . The options set for the group.
■ LocalVV and ID . The name and ID of this system.
■ RemoteVV and ID . The name and ID of the target system.
■ SyncStatus . The following values can appear in the SyncStatus field:
◆ New . Volume is configured as a primary volume, but has not yet been started.
◆ Syncing . Volume is currently synchronizing.
◆ Synced . The primary and secondary volumes are in sync.
◆ NotSynced . The volume is not synchronized, likely the result of an initial sync failure or
some other failure.
◆ Stopped . The volumes were previously synchronized, but may be out of sync due to a
group being stopped.
◆ Stale . Volume was previously synchronized, but a previous synchronization attempt
failed. Thus the secondary has a valid copy, just not a valid copy from the last
synchronization attempt.
■ LastSyncTime . The time at which the last volume synchronization was completed.
Applies only to asynchronous periodic groups. Synchronous groups display N/A if they have
been started and are actively replicating.