HP 3PAR Remote Copy Software - Manual (Page 128)

A.2 Setting Up the Remote Copy Transport Layer for RCIP
Remote Copy User’s Guide InForm OS Version 2.3.1
A.1 Setting Up the Remote Copy Transport Layer for RCIP
Table A-1 summarizes how to configure the Remote Copy pair for RCIP.
Table A-1. RCIP Setup
Step Reference Primary System Backup System
1 Setting Up the
Remote Copy
Interface for RCIP
on page 3.9
showport -rc showport -rc
2 “ For each port:
controlport rcip addr
[-f] <port_IP>
<netmask> <N:S:P>
For each port:
controlport rcip addr
[-f] <port_IP>
<netmask> <N:S:P>
3 Setting the
Gateway on
page 3.9
For each port:
controlport rcip gw
[-f] <gateway_IP>
<N:S:P>
For each port:
controlport rcip gw
[-f] <gateway_IP>
<N:S:P>
4 “ showport -rcip showport -rcip
5 Verifying
Connectivity on
page 3.10
For each port:
controlport rcip ping
<target_IP> <N:S:P>
--
6
(optional)
Increasing MTU
(Optional) on
page 3.11
For each port:
controlport rcip mtu
9000 <N:S:P>
For each port:
controlport rcip mtu
9000 <N:S:P>
7
(optional)
“ For each port:
controlport rcip ping
-s 8972 -pf
<target_IP> <N:S:P>
--