HP 3PAR Remote Copy Software - Manual (Page 156)

B.20 creatercopytarget
Remote Copy User’s Guide InForm OS Version 2.3.1
COMMAND
creatercopytarget
DESCRIPTION
The creatercopytarget command creates a Remote Copy target definition.
SYNTAX
The syntax for the creatercopytarget command can be one of the following:
■ Syntax for Remote Copy over IP (RCIP) is as follows:
creatercopytarget [options] <target_name> IP
[<node:slot:port:IP_address>]...
■ Syntax for Remote Copy over Fibre Channel (FCFC) is as follows:
creatercopytarget [options] <target_name> FC <node_WWN>
[<node:slot:port:WWN>]...
AUTHORITY
Super, Edit
OPTIONS
-disabled
Creates the target in disabled mode.
SPECIFIERS
<target_name>
The name of the target definition to be created, specified by using up to 31 characters.
<node_WWN>
The node’s World Wide Name (WWN) on the target system (Fibre Channel target only).
[<node:slot:port:IP_address>]...
Specifies the node, slot, and port of the Ethernet port on the local system and an IP address
of the peer port on the target system. This specifier can be repeated.
NOTE: You need access to all domains in order to run this command.