HP 3PAR Remote Copy Software - Manual (Page 230)

C.12 Bidirectional Synchronous Disaster Recovery Example
Remote Copy User’s Guide InForm OS Version 2.3.1
5 On the restored system (InServ1), issue the showrcopy command and verify that the
target displays ready, the sending links display Up, the volumes are Syncing, and the
group is displayed as -Rev as shown in bold in the following example:
After the synchronization is verified, restore the direction of each system.
On InServ1:
# showrcopy
Remote Copy System Information
Status: Started, Normal
Target Information
Name ID Type Status Options Policy
InServ2 9 IP ready mirror_config
Link Information
Target Node Address Status Options
InServ2 0 10.100.33.11 Up
InServ2 1 10.101.33.11 Up
receive 0 10.100.33.11 Up
receive 1 10.101.33.11 Up
Group Information
Name Target Status Role Mode Options
sync_group_1 InServ2 Started Secondary-Rev Sync
LocalVV ID RemoteVV ID SyncStatus LastSyncTime
localvv.0 413 remotevv.0 375 Syncing Thu Dec 14 17:58:25 PST 2006
localvv.1 414 remotevv.1 376 Syncing Thu Dec 14 17:58:25 PST 2006
Name Target Status Role Mode Options
sync_group_2.r11 InServ2 Stopped Secondary Sync
LocalVV ID RemoteVV ID SyncStatus LastSyncTime
remotevv.0 423 localvv.0 385 Stopped Thu Dec 14 17:51:49 PST 2006
remotevv.1 424 localvv.1 386 Stopped Thu Dec 14 17:51:44 PST 2006
CAUTION: The group must be started at the time the setrcopygroup restore
command is issued. Issue the showrcopy groups <groupname> command to
confirm the group has been started. If it has not been started then issue the
startrcopygroup <groupname> command and wait for any synchronizations
that are started to complete before issuing the setrcopygroup restore
command.