HP 3PAR Remote Copy Software - Manual (Page 180)

B.44 setrcopytarget
Remote Copy User’s Guide InForm OS Version 2.3.1
enable|disable
Enables or disables the target.
OPTIONS
None.
SPECIFIERS
<target_name>
Specifies the target name for the target definition previously created with the
creatercopytarget command (see creatercopytarget on page B.20).
<policy>
This specifier can only be used with the pol subcommand. The policy can be one of the
following:
mirror_config|no_mirror_config
Specifies that all configuration commands ( creatercopygroup , removercopygroup ,
admitrcopyvv , dismissrcopyvv , setrcopygroup pol/period ,
startrcopygroup , and stoprcopygroup ) involving the specified target are
duplicated ( mirror_config ) or not duplicated ( no_mirror_config ). If not specified,
all configuration commands are duplicated.
<new_name>
The new name for the indicated target. This specifier can only be used with the name
subcommand.
<tput_value>
Specifies the maximum throughput for the indicated target's links, and is used to limit the
total throughput of the links. The throughput value can take a [ g | G ] suffix (gigabytes), [ m | M ]
suffix (megabytes) or [ k | K ] suffix (kilobytes) to indicate size (with no space between the
specified value and size type). The default is kilobytes. Specifying a value of 0 removes the
throughput. This specifier can only be used with the tput subcommand.
NOTE: The no_mirror_config specifier should only be used to allow recovery
from an unusual error condition and only used after consulting your 3PAR
representative.