Setting up the remote copy interface for rcfc, Figure 3-5, 1 setting up the remote copy interface for rcfc – HP 3PAR Remote Copy Software User Manual
Page 76
3.14
Setting the Remote Copy Transport Layer
Remote Copy User’s Guide
InForm OS Version 2.3.1
Figure 3-5. Remote Copy over Fibre Channel Dedicated Node Pairs
3.4.3.1 Setting Up the Remote Copy Interface for RCFC
For Remote Copy over Fibre Channel (RCFC), you must set up the Remote Copy interface for
each storage server in the Remote Copy configuration.
Set the Remote Copy interface for all systems based on the information gathered from
as follows:
1
Set the connection type for each Fibre Channel adaptor port on the primary and backup
storage servers as shown in the following example:
The Fibre Channel adaptor port, as specified by
<N:S:P>
(Node:Slot:Port)
,
is configured as
an RCFC connection (
config rcfc
) in point-to-point mode (
-ct point
). See the InForm
OS Command Line Interface Reference for details about the
controlport config
command.
2
Issue the
showport -rcfc
command to obtain the RCFC port positions.
Repeat steps 1 and 2 for each storage server to obtain all four RCFC port positions to be
used in the Remote Copy configuration. Record this information in
Primary InServ
Backup InServ1
Backup InServ2
Node 0 Node 1
Node 2 Node 3
Node 0 Node 1
Node 1
Node 0
# controlport config rcfc -ct point -f <N:S:P>
# showport -rcfc