Admitrcopytarget – HP 3PAR Remote Copy Software User Manual
Page 141
B.5
admitrcopytarget
InForm OS Version 2.3.1
Remote Copy User’s Guide
COMMAND
admitrcopytarget
DESCRIPTION
The
admitrcopytarget
command adds a target to a Remote Copy volume group.
SYNTAX
admitrcopytarget <target_name> <mode> <group_name>
[<pri_VV_name>:<sec_VV_name>]...
AUTHORITY
Service
OPTIONS
None.
SPECIFIERS
<target_name>
Specifies the name of the target that was previously created with the
creatercopytarget
command (see
).
<mode>
Specifies the mode of the target as either synchronous (
sync
) or asynchronous periodic
(
periodic
).
<group_name>
Specifies the name of the existing Remote Copy volume group created with the
creatercopygroup
command (see
), to which the target will be added.
[<pri_VV_name>:<sec_VV_name>]...
Specifies the mapping between the names of a volume in the primary group and the
corresponding volume on the added target. This specifier must be included for every
volume in the primary volume group. This specifier is not required only if the group
contains no volumes.
NOTE: You need access to all domains in order to run this command.