HP ProCurve 520wl Wireless Access Point - Manual (Page 102)

Other Network Settings
6-19
set the distance between aps set the distance between aps set the distance between aps set the distance between aps
– 3 = wireless card in Slot A
– 4 = wireless card in Slot B
[Device Name]>set wif <3 or 4> distaps <large, medium, small, minicell, microcell>
[Device Name]>reboot 0
This feature is only available for 802.11b wireless cards.
NOTE:
The distance between APs should not be approximated. It is calculated by means of a manual Site Survey, in which
an WL520 unit is set up and clients are tested throughout the area to determine signal strength and coverage, and
local limits such as physical interference are investigated. From these measurements the appropriate cell size and
density is determined, and the optimum distance between APs is calculated to suit your particular business
requirements.
set the multicast rate set the multicast rate set the multicast rate set the multicast rate
– 3 = wireless card in Slot A
– 4 = wireless card in Slot B
[Device Name]>set wif <3 or 4> multrate <1,2,5.5,11
(Mbps)>
This feature is only available for 802.11b wireless cards.
NOTE:
The Distance Between APs must be set before must be set before must be set before must be set before the Multicast Rate.
set ethernet speed and transmission mode set ethernet speed and transmission mode set ethernet speed and transmission mode set ethernet speed and transmission mode
[Device Name]>set etherspeed <value (see below)>
[Device Name]>reboot 0
set interface management services set interface management services set interface management services set interface management services
set communication ports set communication ports set communication ports set communication ports
[Device Name]>set httpport <HTTP port number
(default is 80)>
[Device Name]>set telport <Telnet port number
(default is 23)>
set telnet session timeouts set telnet session timeouts set telnet session timeouts set telnet session timeouts
[Device Name]>set tellogintout <time in seconds>
[Device Name]>set telsessiontout <time in seconds>
ethernet speed and transmission mode ethernet speed and transmission mode ethernet speed and transmission mode ethernet speed and transmission mode value value value value
10 Mbit/s - half duplex 10halfduplex
10 Mbit/s - full duplex 10fullduplex
10 Mbit/s - auto duplex 10autoduplex
100 Mbit/s - half duplex 100halfduplex
100 Mbit/s - full duplex 100fullduplex
Auto Speed - half duplex autohalfduplex
Auto Speed - auto duplex autoautoduplex (recommended)