HP ProCurve 520wl Wireless Access Point - Manual (Page 52)

Network Settings
4-3
dhcp ip pool table settings dhcp ip pool table settings dhcp ip pool table settings dhcp ip pool table settings
To add an entry, click Add Add Add Add , and then specify the start and end IP Address.
– Start IP Address Start IP Address Start IP Address Start IP Address . Enter the starting IP Address for this IP Pool Table.
– End IP Address End IP Address End IP Address End IP Address . Enter the ending IP Address for this IP Pool Table.
– Comment Comment Comment Comment . Enter related information.
– Default Lease Time (optional) Default Lease Time (optional) Default Lease Time (optional) Default Lease Time (optional) - the default time value for clients to retain the assigned IP Address. DHCP automatically
renews IP Addresses without client notification. Default is 86400 seconds.
– Maximum Lease Time (optional) Maximum Lease Time (optional) Maximum Lease Time (optional) Maximum Lease Time (optional) - the maximum time value for clients to retain the assigned IP Address. DHCP automatically
renews IP Addresses without client notification. Default is 86400 seconds.
– Status Status Status Status . Shows enabled/disabled status.
To edit or delete an entry, click Edit Edit Edit Edit . Edit the information, or select Enable Enable Enable Enable , Disable Disable Disable Disable , or Delete Delete Delete Delete from the
Status
pull-down menu.
link integrity settings link integrity settings link integrity settings link integrity settings
This feature checks the link between the WL520 and connected network server(s). If the link goes down then the client will
connect to another WL520 in your network that still communicates with the server.
NOTE:
This feature is only applicable to 2.4 GHz (802.11b) cards.
Figure 4-2 Figure 4-2 Figure 4-2 Figure 4-2 Link Integrity Configuration Screen Link Integrity Configuration Screen Link Integrity Configuration Screen Link Integrity Configuration Screen
– Enable Link Integrity Enable Link Integrity Enable Link Integrity Enable Link Integrity . Place a check mark in the box provided to activate the Link Integrity feature.
– Poll Interval Poll Interval Poll Interval Poll Interval . Set the interval (minimum 500ms and in increments of 500ms) between polls.
– Poll Retransmissions Poll Retransmissions Poll Retransmissions Poll Retransmissions . Set the number of times a poll should be retransmitted before the link is considered down.
target ip address table settings target ip address table settings target ip address table settings target ip address table settings
To add an Target IP Address entry, click Add Add Add Add , and then specify the IP Address of the servers you want to check.
– Target IP Address Target IP Address Target IP Address Target IP Address . Enter the IP Address
– Comments Comments Comments Comments . Enter related information.
– Status Status Status Status . Shows enabled/disabled status. A disabled status only means that the WL520 is not checking the link, for example,
when the network server is being serviced.
To edit or delete an entry, click Edit Edit Edit Edit . Edit the information, or select Enable Enable Enable Enable or Disable Disable Disable Disable from the
Status
pull-down menu.