HP ProCurve 520wl Wireless Access Point - Manual (Page 55)

VLAN Support
4-6
1. In the Web Interface, click the Configure Configure Configure Configure button and select the Interfaces Interfaces Interfaces Interfaces tab.
2. Enter a unique unique unique unique Network Name Network Name Network Name Network Name (SSID) for each wireless network interface card (NIC).
3. Select the Network Network Network Network tab and select the VLAN VLAN VLAN VLAN sub-tab.
4. Set a unique unique unique unique VLAN User ID for each wireless NIC (enter a value between 1 and 4094).
5. Place a checkmark in the Enable VLAN Protocol box.
6. Configure the wireless client with one of the two
Network Names Network Names Network Names Network Names based on VLAN membership.
setting up independent vlan workgroups (tagged & untagged) setting up independent vlan workgroups (tagged & untagged) setting up independent vlan workgroups (tagged & untagged) setting up independent vlan workgroups (tagged & untagged)
The VLAN-capable WL520 supports configuration of both “tagged” and “untagged” user VLANs.
A “tagged” user VLAN is created when a VLAN ID between 1 and 4094 (per the 802.1Q standard) is configured for one of
the wireless NICs and VLAN is enabled. The WL520 applies a VLAN header to tag traffic from wireless clients (members of a
“tagged” VLAN) and transmits the traffic as appropriate, on either the wired or wireless backbone.
An “untagged” User VLAN is created when a VLAN ID of 0 is configured for one of the wireless NICs and VLAN is enabled.
Traffic received from wireless clients (members of an “untagged” VLAN) is transmitted as appropriate, on either the wired or
wireless backbone. “Untagged” User VLANs enable VLANs to coexist on networks with non-VLAN capable devices such as
legacy servers.
To configure this scenario, set up only one workgroup by configuring one tagged interface and one untagged interface:
Q
VLAN ID for Wireless NIC in Slot A = 0 or a number between 1 and 4094
Q
VLAN ID for Wireless NIC in Slot B = 0 or a number between 1 and 4094
NOTE:
Either the wireless NIC in Slot A or the wireless NIC in Slot B must be set to 0.
Figure 4-5 Figure 4-5 Figure 4-5 Figure 4-5 VLAN Configuration Screen (Wireless A Tagged Only) VLAN Configuration Screen (Wireless A Tagged Only) VLAN Configuration Screen (Wireless A Tagged Only) VLAN Configuration Screen (Wireless A Tagged Only)
1. In the Web Interface, click the Configure Configure Configure Configure button and select the Interfaces Interfaces Interfaces Interfaces tab
2. Enter a unique unique unique unique Network Name Network Name Network Name Network Name (SSID) for each NIC.
3. Select the Network Network Network Network tab and select the VLAN VLAN VLAN VLAN sub-tab.
4. Set the VLAN UserID VLAN UserID VLAN UserID VLAN UserID for one NIC to 0.
5. Set the VLAN User ID VLAN User ID VLAN User ID VLAN User ID for the other NIC to a value between 1 and 4094.
6. Place a checkmark in the Enable VLAN Protocol box.
7. Configure the wireless client with one of the two
Network Names Network Names Network Names Network Names based on VLAN membership.