HP ProCurve 520wl Wireless Access Point - Manual (Page 62)

Setting Filters
4-13
Figure 4-12 Figure 4-12 Figure 4-12 Figure 4-12 TCP/UDP Port Filtering Configuration Screen TCP/UDP Port Filtering Configuration Screen TCP/UDP Port Filtering Configuration Screen TCP/UDP Port Filtering Configuration Screen
adding tcp/udp port filters adding tcp/udp port filters adding tcp/udp port filters adding tcp/udp port filters
1. In the Web Interface, click the Configure Configure Configure Configure button and select the Filtering Filtering Filtering Filtering tab.
2. Select the TCP/UDP Port TCP/UDP Port TCP/UDP Port TCP/UDP Port sub-tab.
3. Click the box to Enable TCP/UDP Port Filtering Enable TCP/UDP Port Filtering Enable TCP/UDP Port Filtering Enable TCP/UDP Port Filtering.
4. Under the heading, TCP/UDP Port Filter Table TCP/UDP Port Filter Table TCP/UDP Port Filter Table TCP/UDP Port Filter Table , click Add Add Add Add .
Figure 4-13 Figure 4-13 Figure 4-13 Figure 4-13 Adding a Port to the TCP/UDP Port Filter Table Adding a Port to the TCP/UDP Port Filter Table Adding a Port to the TCP/UDP Port Filter Table Adding a Port to the TCP/UDP Port Filter Table
5. In the TCP/UDP Port Filter Table TCP/UDP Port Filter Table TCP/UDP Port Filter Table TCP/UDP Port Filter Table, enter the Protocol Names to filter.
6. Set the destination Port Number (a value between 0 and 65535) to filter. See the IANA Web site at
http://www.iana.org/assignments/port-numbers for a list of assigned port numbers and their descriptions.
7. Set the Port Type for the protocol: TCP, UDP, or both (TCP/UDP).
8. Set the
Interface Interface Interface Interface to filter (any combination of the following):
Q
Wireless Slot A; Wireless Slot B; Ethernet
9. Click OK OK OK OK .
NOTE:
Filters are enabled by default. Frames that the WL520 receives on the specified interface(s) with the specified
TCP/UDP destination port, are discarded.