HP ProCurve 520wl Wireless Access Point - Manual (Page 63)

Alarms (SNMP Traps)
4-14
editing tcp/udp port filters editing tcp/udp port filters editing tcp/udp port filters editing tcp/udp port filters
1. In the Web Interface, click the Configure Configure Configure Configure button and select the Filtering Filtering Filtering Filtering tab.
2. Select the TCP/UDP Port TCP/UDP Port TCP/UDP Port TCP/UDP Port sub-tab.
3. Under the heading, TCP/UDP Port Filter Table TCP/UDP Port Filter Table TCP/UDP Port Filter Table TCP/UDP Port Filter Table , click the button marked Edit Edit Edit Edit.
4. Make any changes to the Protocol Name or Port Number for a specific entry, if necessary.
5. In the row that defines the port, set the
Status Status Status Status to enable enable enable enable , disable disable disable disable , or delete delete delete delete as appropriate.
6. Select OK OK OK OK.
alarms (snmp traps) alarms (snmp traps) alarms (snmp traps) alarms (snmp traps)
alarm (trap) groups alarm (trap) groups alarm (trap) groups alarm (trap) groups
Figure 4-14 Figure 4-14 Figure 4-14 Figure 4-14 Alarm Groups Configuration Screen Alarm Groups Configuration Screen Alarm Groups Configuration Screen Alarm Groups Configuration Screen
There are seven alarm groups that can be enabled or disabled: There are seven alarm groups that can be enabled or disabled: There are seven alarm groups that can be enabled or disabled: There are seven alarm groups that can be enabled or disabled:
–
Enable Configuration Alarms Enable Configuration Alarms Enable Configuration Alarms Enable Configuration Alarms .
– Enable Security Alarms Enable Security Alarms Enable Security Alarms Enable Security Alarms .
– Enable Wireless Alarms Enable Wireless Alarms Enable Wireless Alarms Enable Wireless Alarms .
– Enable Operational Alarms Enable Operational Alarms Enable Operational Alarms Enable Operational Alarms .
– Enable Flash Memory Alarms Enable Flash Memory Alarms Enable Flash Memory Alarms Enable Flash Memory Alarms .
– Enable TFTP Alarms Enable TFTP Alarms Enable TFTP Alarms Enable TFTP Alarms .
– Enable Image Alarms Enable Image Alarms Enable Image Alarms Enable Image Alarms . Place a checkmark in the box provided to enable a specific group. Remove the checkmark from the
box to disable the alarms.
See System Alarms (Traps) for the list of alarms contained in each group.
alarm host table alarm host table alarm host table alarm host table
To add an entry and enable the WL520 to send SNMP trap messages to a Trap Host, click Add Add Add Add , and then specify the IP
Address and Password for the Trap Host.
–
IP Address IP Address IP Address IP Address . Enter the Trap Host IP Address.
– Password, Confirm Password, Confirm Password, Confirm Password, Confirm . Enter the password in the Password Password Password Password field and the Confirm Confirm Confirm Confirm field.
– Comment Comment Comment Comment . Enter an optional comment, such as the alarm (trap) host station name.
– To edit or delete an entry, click Edit Edit Edit Edit . Edit the information, or select Enable Enable Enable Enable, , , , Disable Disable Disable Disable , or Delete Delete Delete Delete from the
Status
pull-down
menu.