HP ProCurve 520wl Wireless Access Point - Manual (Page 70)

Wireless Distribution System (WDS)
4-21
wds setup procedure wds setup procedure wds setup procedure wds setup procedure
NOTE:
WDS and ACS cannot be Enabled at the same time on the same card.
To setup a wireless backbone follow the steps below for each WL520 that you wish to include in the wireless distribution
system. Since WDS and ACS cannot be Enabled at the same time on the same card, the first step must be to ensure ACS is
disabled. Follow the process described in Disabling ACS in Configuring the hp WL520 .
Figure 4-23 Figure 4-23 Figure 4-23 Figure 4-23 Wireless Interface Screen - WDS Configuration Wireless Interface Screen - WDS Configuration Wireless Interface Screen - WDS Configuration Wireless Interface Screen - WDS Configuration
1. Write down the MAC Address of the hp wireless PC Card WL110 inside the wireless slot of the WL520 that you wish to
include in the wireless distribution system (this value is printed on a label on the back of the WL110 PC Card).
2. In the Web Interface, click the Configure Configure Configure Configure button and select Interfaces Interfaces Interfaces Interfaces .
3. Select the Wireless Wireless Wireless Wireless sub- sub- sub- sub- tab that corresponds to the card’s location (slot A or B).
4. Click the Edit Edit Edit Edit button to update the Wireless Distribution System (WDS) Table.