HP ProCurve 520wl Wireless Access Point - Manual (Page 33)

Other Security Configuration Settings
2-20
set http interface management services set http interface management services set http interface management services set http interface management services
1. In the Web Interface, click the Configure Configure Configure Configure button and select the Management Management Management Management tab.
2. Choose the Services Services Services Services sub-tab.
3. For each service, there is a list of associated settings. From the drop-down menu, select which physical interface(s) can be
used to manage the WL520 device using the Web interface. For example, to allow Web configuration via the Ethernet
network only, set HTTP Interface Bitmask HTTP Interface Bitmask HTTP Interface Bitmask HTTP Interface Bitmask to Ethernet Ethernet Ethernet Ethernet. The available configuration options are:
— Disabled (all interfaces)
— Ethernet only enabled
— Wireless A only enabled
— Wireless B only enabled
— All Interfaces enabled
4. Enter the HTTP communication port number. Default is 80.
NOTE:
See Configuring Management Service Interfaces for information on the SNMP, Telnet, and other HTTP parameters
that can be configured from the Services screen.
configure serial port interface settings configure serial port interface settings configure serial port interface settings configure serial port interface settings
The serial port interface on the WL520 device is enabled at all times. You can set the following parameters as needed:
–
Baud Rate Baud Rate Baud Rate Baud Rate . Select the serial port speed (bits per second). Choose between 2400, 4800, 9600, 19200, 38400, or 57600;
the default Baud Rate is 9600 9600 9600 9600 .
– Flow Control Flow Control Flow Control Flow Control . Select either None None None None (default) or Xon/Xoff Xon/Xoff Xon/Xoff Xon/Xoff (software controlled) data flow control.
NOTE:
To avoid unexpected performance of your WL520, leave the setting Flow Control to its default value (none) unless you
are sure what this setting should be.
other security configuration settings other security configuration settings other security configuration settings other security configuration settings
Control access to the WL520 device using MAC Address authentication, WEP encryption, or 802.1x security settings.
configure your mac (address) access control table configure your mac (address) access control table configure your mac (address) access control table configure your mac (address) access control table
Figure 2-20 Figure 2-20 Figure 2-20 Figure 2-20 Security Configuration Screen - MAC Authentication Security Configuration Screen - MAC Authentication Security Configuration Screen - MAC Authentication Security Configuration Screen - MAC Authentication