HP ProCurve 520wl Wireless Access Point - Manual (Page 104)

Other Network Settings
6-21
set radius parameters set radius parameters set radius parameters set radius parameters
configure radius authentication server configure radius authentication server configure radius authentication server configure radius authentication server
[Device Name]>set radiustbl <index> status enable seraddrfmt <ipaddr or name>
ipaddr <RADIUS IP address or name> port <user defined>
ssecret <user defined> responsetm <1 to 4 seconds>
maxretx <1 to 10 times>
[Device Name]>show radiustbl
Figure 6-15 Results of “show radiustbl” CLI command
enable radius mac access control enable radius mac access control enable radius mac access control enable radius mac access control
[Device Name]>set radmacaccctrl enable
[Device Name]>reboot 0
set mac address format type set mac address format type set mac address format type set mac address format type
[Device Name]>set radmacaddrformat <dashdelimited, colondelimited, singledashdelimited,
nodelimiter>
set authentication lifetime set authentication lifetime set authentication lifetime set authentication lifetime
[Device Name]>set radauthlifetm <60-43200 seconds (in 60 sec increments)>
enable radius accounting enable radius accounting enable radius accounting enable radius accounting
[Device Name]>set radaccstatus enable
[Device Name]>set radaccinactivetmr <inactivity timer in minutes>
[Device Name]>show radius
Figure 6-16 Figure 6-16 Figure 6-16 Figure 6-16 Result of “show radius” CLI Command Result of “show radius” CLI Command Result of “show radius” CLI Command Result of “show radius” CLI Command