HP ProCurve 520wl Wireless Access Point - Manual (Page 58)

Management Settings
4-9
managing ip access managing ip access managing ip access managing ip access
Figure 4-8 Figure 4-8 Figure 4-8 Figure 4-8 IP Access Table Configuration Screen IP Access Table Configuration Screen IP Access Table Configuration Screen IP Access Table Configuration Screen
The Management IP Access table is used to specify a station or stations that are authorized to manage the WL520 device
through available management services (SNMP, HTTP [Web], and Telnet [CLI]). To configure this table, click Add Add Add Add and set the
following parameters:
–
IP Address IP Address IP Address IP Address . Enter the IP Address for the management station.
– IP Mask IP Mask IP Mask IP Mask . Enter a mask that will act as a filter to limit access to a range of IP Addresses.
– Comment Comment Comment Comment . Enter an optional comment such as the station name.
NOTE:
The IP mask 255.255.255.255 would authorize the single station defined by the IP Address to configure the Access
Point device. The Access Point device would ignore commands from any other IP address. In contrast, the IP mask
255.255.255.0 would authorize anyone on the subnet shared by the IP Address anyone on the subnet shared by the IP Address anyone on the subnet shared by the IP Address anyone on the subnet shared by the IP Address to configure the Access Point device.
To edit or delete an entry, click Edit Edit Edit Edit . Edit the information, or select Enable Enable Enable Enable , Disable Disable Disable Disable , or Delete Delete Delete Delete from the
Status
pull-down menu.