HP StorageWorks 1510i Modular Smart Array - Manual (Page 23)

iSNS enabled
• To manually add iSNS servers
a. Use the set isns command to change the iSNS server discovery mode:
CLI> set isns server_discovery=manual
iSNS parameters set.
b. Use the add isns_server command to add the IP address of the iSNS server:
CLI> add isns_server 20.20.20.26
The iSNS server was added successfully.
Alias: isns1
c. Use the set discovery command to enable iSNS discovery on the iSCSI target.
CLI> set discovery target1 isns=enable
iSNS enabled
Enable SLP discovery of the iSCSI target
NOTE:
Steps in this section assume that you already have a basic iSCSI setup configured.
Use the set discovery command to enable SLP discovery on the iSCSI target:
CLI> set discovery target1 slp=enable
SLP enabled
Configure static management settings
To access the MSA1510i management functionality over a network that does not use DHCP, and on which
your management host cannot access the default zeroconf* IP address, you must set up a static IP address.
1. Configure management to use a static IP address using the set management command:
CLI> set management dhcp=disable ip=192.168.1.10/255.255.255.0
gateway=192.168.1.1
2. [Optional] If you have not done so already, configure a login and password for accessing
management functionality using the set management_login command:
CLI> set management_login <user_ID> <password>
where <user_ID> and <password> are your own unique settings.
3. [Optional] Switch management functionality to a different physical port using the set management
command:
CLI> set management port=MA1
1510i Modular Smart Array Command Line Interface user guide 23