HP StorageWorks 1510i Modular Smart Array - Manual (Page 88)

set management
Description Sets global management interface settings for the system.
Syntax set management [disable|enable] [port=<port>]
[dhcp=<dhcp>] [hostname=<name>] [domain=<domain>]
[ip=<ip>[/<mask>]|default>] [gateway=<ip>] [dns1=<ip>]
[dns2=<ip>] [vlan=<vlan>] [ntp=<ip>]
Operands
NOTE:
Although all parameters are optional, at least one parameter must be
supplied for the command to be valid.
NOTE:
If a parameter is not specified then the current setting must not be
changed.
disable|enable
• disable—disables the management interface on the storage system.
All management interface settings are retained and may be restored by
later issuing a set management enabled command.
• enable—enables the management interface on the storage system if it
was previously disabled.
port=<port>
A valid management port name, such as MA0, to be used as the
management interface port.
dhcp=<dhcp>
• on—activates DHCP for the management interface. This causes the
configured static IP address to be removed.
• off—deactivates DHCP for the management interface. The configured
static IP address is used, or if no static IP is configured, the system
defaults to a zeroconf setup.
hostname=<name>
The network host name for this system. For example, myarray.
domain=<domain>
The domain suffix for this system. For example, hp.com.
<ip[/<mask>]|default>
The IP address in dotted notation. If default is entered instead of an IP
address, the default gateway will be used.
If a subnet mask is included with the ip address, it must be entered in dotted
notation or number of bits and must be entered directly after the IP address,
separated with a slash (/) character (no spaces).
88 Command reference