HP StorageWorks Enterprise File Services WAN Accelerator - Manual (Page 40)

40 2 C ONFIGURING THE HP EFS WAN A CCELERATOR
Setting Host Parameters
This section describes how to set host parameters for the HP EFS WAN Accelerator.
It includes the following topics:
‹ “Setting the Primary Interface,” next
‹ “Setting In-Path Interfaces” on page 42
‹ “Setting Auxiliary Interfaces” on page 46
‹ “Setting Main Static Routes” on page 48
‹ “Setting Static In-Path Routes” on page 49
‹ “Setting the DNS” on page 50
‹ “Mapping Hosts to IP Addresses” on page 53
‹ “Setting Proxies” on page 54
Setting the
Primary
Interface
You modify settings for the primary interface in the Host Settings - Interface Primary
page.
IMPORTANT: The primary and in-path interfaces can share the same subnet. The primary and
auxiliary interfaces cannot share the same network subnet.
NOTE: You were prompted to configure the primary interface when you completed the
installation wizard. This section describes how you can modify these settings.