HP StorageWorks Enterprise File Services WAN Accelerator - Manual (Page 91)

HP S TORAGE W ORKS EFS WAN A CCELERATOR M ANAGEMENT C ONSOLE U SER G UIDE 91
2 C
ONF
IGUR
ING
TH
E
HP
EF
S
W
AN A
CC
EL
E
R
A
T
O
R
4. Click Apply to apply your settings to the running configuration. (Apply your
settings to test a new configuration before committing it to memory.)
5. Click Save to write your settings to memory or click Reset to return the settings to
their previous values.
Setting Email
Notification
You can set email notification parameters for events and failures in the
Reports - Notification page.
By default email addresses are not specified for event and failure notification.
Warning Temperature Alarm Raise Alarm When Temperature (°C) Reaches. Check this box to trigger an alarm
when the CPU temperature exceeds the rising threshold. When the CPU cools to the reset
threshold, the rising alarm is cleared. The default value for CPU temperature is 47º C.
The warning temperature threshold must be lower than the critical temperature threshold.
Rising Threshold. Type a whole number to specify a temperature (º C).
Reset Threshold. Type a whole number to specify a temperature (º C).
Additional Alarms Raise Alarm When Network Interface Duplex Errors are Detected. Check this box to
trigger an alarm if the system has encountered a large number of packet errors in your
network. Make sure the speed and duplex settings on your HP EFS WAN Accelerator
match the settings on your switch and router.
This alarm is enabled by default.
Raise Alarm When Network Interface Link Errors are Detected. Check this box to
trigger an SNMP trap, email, and alarm notification when a link goes down. This alarm is
disabled by default.
For WAN/LAN interfaces, an alarm is only triggered if in-path support is enabled for that
WAN/LAN pair.
Raise Alarm When Extended Memory Paging Activity is Detected. Check this box to
trigger the memory paging alarm. If 100 pages are swapped every couple of hours, the
appliance is functioning properly. If thousands of pages are swapped every few minutes,
contact HP technical support.
This alarm is enabled by default.
Raise Alarm If a Software Version Mismatch is Detected in the Network. Check this
box to trigger an alarm if there is a mismatch between software versions in the HP
system.
This alarm is enabled by default.
Control Description