HP StorageWorks Enterprise File Services WAN Accelerator - Manual (Page 90)

90 2 C ONFIGURING THE HP EFS WAN A CCELERATOR
To set alarm
parameters 1. Click the Setup tab to display the setup menu.
2. Click Reports to display the Reports - Alarm Settings page.
Figure 2-33. Reports - Alarm Settings Page
3. Use the controls to complete the configuration, as described in the following table.
Control Description
CPU Alarms Raise Alarm When CPU Utilization Reaches. Check this box to trigger an alarm if the
average and peak threshold for the Central Processing Unit (CPU) utilization is
exceeded. When an alarm reaches the rising threshold, it is activated; when it reaches the
lowest or reset threshold, it is reset. After an alarm is triggered, it is not triggered again
until it has fallen below the reset threshold.
This alarm is enabled by default, with a rising threshold of 90% and a reset threshold of
70%.
Rising Threshold. Type a whole number to specify a percent of CPU utilization.
Reset Threshold. Type a whole number to specify a percent of CPU utilization.
Data Store Alarm Send email if stale data replaced by fresh data is less than __ day(s) old. Check this
box to trigger an alarm if data in the data store is replaced with new data before the time
period specified.