HP StorageWorks Enterprise File Services WAN Accelerator - Manual (Page 70)

70 2 C ONFIGURING THE HP EFS WAN A CCELERATOR
2. Use the controls to complete the configuration, as described in the following table.
3. Click Save to write your settings to memory or click Reset to return the settings to
their previous values.
Enabling WCCP
Groups
You can enable WCCP service groups in the Advanced Networking - WCCP Service
Groups page.
WCCP enables you to redirect traffic that is not in the direct physical path between the
client and the server. To enable WCCP, the HP EFS WAN Accelerator must join a
service group at the router. A service group is a group of routers and HP EFS WAN
Accelerators which define the traffic to redirect, and the routers and HP EFS WAN
Accelerators the traffic goes through.
Enabling WCCP is optional.
TIP: You can also use the HP EFS WAN Accelerator CLI to configure WCCP service groups.
For detailed configuration information (including configuring the WCCP router), see the HP
StorageWorks Enterprise File Services WAN Accelerator Deployment Guide.
NOTE: The following section assumes you are familiar with WCCP. For detailed information
about WCCP, see the Cisco documentation Web site at
http://www.cisco.com/univercd/home/home.htm.
Control Description
Mappings Data Collection Settings None. All options are disabled.
Destination Only. Collects destination MAC data.
This option can be used in connection forwarding.
Destination and Source. Collect mappings from destination and source MAC data.
This option cannot be used in connection forwarding.
All. Collect mappings for destination and source MAC data and data. It also collects
data for connections that are un-natted (that is, connections that are not translated using
Network Address Translation (NAT).
This option must be disabled in connection forwarding configurations.