HP LaserJet 8000 Multifunction Printer series User Manual
Page 171
Chapter 5
Problem Solving
171
Understanding Printer Messages
EIO n
INITIALIZING
alternates with
DO NOT POWER OFF
Wait for the message to disappear (approximately 5 minutes). If the
printer EIO card is operating correctly and communicating with the
network, this message disappears after approximately one minute
and no action is required.
If the EIO card is unable to communicate with the network, this
message remains for five minutes and then disappears. In this case
the printer is not communicating with the network (even though the
message is no longer present). The problem may be a bad EIO card,
a bad cable or connection on the network, or a network problem.
Contact your network administrator.
EIO n DISK
SPINNING UP
The disk accessory card takes a long time to initialize. The first
parameter is the accessory slot number for this accessory card.
ENV FEEDER LOAD
[TYPE] [SIZE]
Load the requested envelope type and size into the envelope feeder.
Make sure the envelope size and type are set correctly from the
Paper Handling Menu in the printer’s control panel (page
Press
G
O
if the desired envelope is already loaded in the feeder.
Press
- V
ALUE
+
to scroll through the available types and sizes. Press
S
ELECT
to accept the alternate type or size.
EXTERNAL DEVICE
INITIALIZING
When an external paper handling device is connected to the printer,
it must have 10 seconds to initialize after boot or after coming out of
Power Save mode.
Printer Messages (continued)
Message
Explanation or Recommended Action