HP XP7 Storage - Manual (Page 218)

Table 45 System log messages (continued)
Recommended action Cause Condition Message ID
Restart the system, and contact the HP
Technical Support. An internal error that could not be
identified by the HORCM
occurred. HORCM assertion failed,
resulting in a fatal internal
error in the HORCM. HORCM_004
Refer to the HORCM startup log to identify
the cause of the error. HORCM failed to create a socket,
or an error exists in the format or The RAID Manager software
failed to create the end point
for remote communication. HORCM_005
a parameter in the HORCM
configuration file
($HORCM_CONF).
Increase the system virtual memory, or
close any unnecessary programs. HORCM memory could not be
secured. HORCM memory allocation
failed. HORCM_006
Refer to the startup log and reset the
parameters. An error exists in the parameter
value setting in the HORCM setup
file. An error exists in the
parameter value in the
HORCM setup file. HORCM_007
Refer to the HORCM startup log to identify
the cause of the error. An error exists in the format or
parameters of the HORCM HORCM configuration file
parameters reading fails. HORCM_008
configuration file
($HORCM_CONF).
Refer to the HORCM startup log to identify
the cause of the error. System devices are improperly
connected, or an error exists in Continuous Access
Synchronous/Business Copy HORCM_009
the device parameter in the
HORCM configuration file. connection to the RAID
Manager software failed.
Refer to the HORCM startup log to identify
the cause of the error. A system I/O error occurred or
an error exists in the device Continuous Access
Synchronous/Business Copy HORCM_101
parameter in the HORCM and the RAID Manager
configuration file
($HORCM_CONF). software communication
fails.
Contact the HP Technical Support. The pair status was suspended
due to code XXXX. The volume is suspended. HORCM_102
Please confirm the following items, and
use raidvchkdsp -v <op> command
for verifying the validation parameters. A validation error occurs on the
database volume, or validation
parameters for this volume are
illegal. Detected a validation check
error on this volume (xxxx
unit#x,ldev#x) : CfEC=n,
MNEC=n, SCEC=n,
BNEC=n HORCM_103
(1)Check if the block size (-vs <size>) is
an appropriate size.
(2)Check if the type for checking (-vt
<type>) is an appropriate type.
(3)Check if the data validations are
disabled for LVM configuration changes.
(4)Check if the data validations are not
shared on file system.
(5)Check if the redo log and data file are
separated among the volumes.
Command error messages
The following table lists and describes the command error messages and their return values and
provides recommended action for resolving the error conditions.
They are typical messages of command error messages. Check the command log file for details
of the error. For more details about the command log file, see
“RAID Manager log files” (page 45) .
218 Troubleshooting