HP XP7 Storage - Manual (Page 281)

Table 92 SSB codes that are returned by raidcom add rcu command (continued)
raidcom add rcu
Description Error code Executing/
Async Error message
SSB2 SSB1
•
Cable is not connected correctly.
• Port is specified incorrectly.
The operation cannot be done because the microcode is being
changed. 8004 2E11 Async Get Command Status
The command cannot be accepted. After a while, execute the
same command. 9400 2E11 Executing CMDRJE
The serial number, the product ID, or the SSID of the target
storage system is incorrect. 3000 2E20 Async Get Command Status
The specified CU number is not defined, or an LDEV is not
defined under the CU number. 7101 2E21 Async Get Command Status
The specified RCU is already registered to another product ID. 3001 2E22 Async Get Command Status
The operation cannot be performed due to one of the following
reasons: 3002 2E22 Async Get Command Status
• The number of RCUs registered in MCU or RCU is more than
four.
•
The number of RCUs registered in the system is more than
64 in the case of specifying the cu free.
The specified SSID is already registered to another RCU. 3300 2E22 Async Get Command Status
The specified RCU is cannot be registered because there is no
free RCU. 3000 2E23 Async Get Command Status
The operation cannot be done because the number of paths
becomes less than the least path number. 3101 2E23 Async Get Command Status
The port attribute is not Initiator (MCU). 840A 2E30 Executing CMDRJE
Command cannot be executed because the RCU identification
code of a path is invalid. 3001 2E31 Async Get Command Status
The operation cannot be performed because the remote storage
system does not support the path between CUs. 3002 2E31 Async Get Command Status
Command cannot be executed because the serial number is not
unified in the specified path. 3101 2E31 Async Get Command Status
The command cannot be accepted because the DKC is busy.
After a while, execute the same command. 00EE 2ED6 Executing CMDRJE
An internal error occurred. 3005 2ED6 Async Get Command Status
Call HP Technical Support.
The value of SSID on the remote storage system is invalid. 3300 2ED6 Executing CMDRJE
The specified parameter is invalid. Check the HP XP7 RAID
Manager Reference Guide. 3002 2EF3 Executing CMDRJE
Error messages and error codes 281