HP 3PAR Service Processors - Manual (Page 19)

Table 1 SP Process Control Parameters (continued)
Notes Default Value ID
When a file’s size exceeds the maximum Ethernet size, break the file
down into parts this size, in kilobytes 52428800 10
Controls whether files are transferred over modem when Remote
Operation is active True 11
File types that should be transferred first (there is a maximum of five, and
they should be in a comma-separated list) NONE 12
Controls the grouping of small files for transfer True 13
Maximum number of files that can be grouped together for transfer 50 14
Wait this number of seconds before closing the current file group 60 15
To edit the file transfer process parameters on the SP:
1.
From the SP Process Control submenu, enter 1 for Alter Process Control Parms, and then press
Enter.
The screen displays the current file transfer process settings.
2. Enter the number corresponding to the process that you want to reconfigure, and then press
Enter.
3. Enter the ID number corresponding to the parameter that is selected for editing, and then press
Enter.
4. Enter a new value for the parameter, and then press Enter.
5. You are prompted to enter additional parameter IDs.
6. When you are finished editing parameters, enter 0, and then press Enter.
7. When prompted, enter y, and then press Enter to save and activate your changes.
Saving and activating your changes automatically returns you to the SP Control submenu.
Running a SPLOR or an MSPLOR
To collect data to diagnose SP issues, run a Service Processor Log Out Request (SPLOR). To collect
data to diagnose SP installation issues, run a Mini Service Processor Log Out Request (MSPLOR).
To run a SPLOR by using SPOCC:
1.
On the SPOCC home page, click the Support tab.
2. Under Service Processor, click Launch SPLOR. The SPLOR opens in a new window.
3. When the SPLOR is complete, click View SPLOR Contents.
To run a SPLOR by using SPMAINT:
1.
From the SPMAINT main menu, enter 1 for SP Control/Status, and then press Enter.
2. Enter 19 for Take a SPLOR, and then press Enter.
3. Once finished, press Enter to continue.
To run an MSPLOR:
1.
From the SPMAINT main menu, enter 1 for SP Control/Status, and then press Enter.
2. Enter 20 for Take an MSPLOR, and then press Enter.
3. Once finished, press Enter to continue.
Running SP Check Health
In SP 4.2.0, a new “SP Check Health” feature is added to the SP Control/Status menu. This feature
detects whether a storage system has duplicate IP addresses. To run the SP Check Health feature
by using SPOCC:
Running a SPLOR or an MSPLOR 19