HP 3PAR Service Processors - Manual (Page 22)

3. Click Network Configuration.
4. Click Firewall Manipulation.
5. Click Disable Permissive Mode.
Changing the Public Network Interface Parameters
Changing the SP Default Route
Changing the SP default route affects the network setting for handling routing decisions to
destinations that are not local to the SP. The SP default route is the communication link to a proxy
host or the outside world. Typically, the same host is designated as the gateway (for more
information, see
“Changing the SP Default Gateway” (page 23) ).
To change the SP default route by using SPOCC:
1.
On the SPOCC home page, click the SPmaint tab.
2. Click Network Configuration.
3. Click Change Public Network Interface Parameters.
4. Enter a new default route in the Default Route field, and then click Save and Activate.
To change the SP default route by using SPMAINT:
1.
From the SPMAINT main menu, enter 2 for Network Configuration, and then press Enter.
2. Enter 4 for Change public network interface parameters, and then press Enter.
3. Enter 2 for Change Default Route, and then press Enter.
4. Enter a new default route, and then press Enter.
5. The SP Network submenu appears. The new default route is displayed to the right of the current
default route. Enter A, and then press Enter to quit, save, and activate the new default route.
Changing the SP IP Address
To change the Service Processor’s IP address by using SPOCC:
1.
On the SPOCC home page, click the SPmaint tab.
2. Click Network Configuration.
3. Click Change Public Network Interface Parameters.
4. Enter a new IP address in the IP Address field, and then click Save and Activate.
To change the Service Processor’s IP address by using SPMAINT, select the following menu options
from the SPMAINT main menu:
1.
From the SPMAINT main menu, enter 2 for Network Configuration, and then press Enter.
2. Enter 4 for Change public network interface parameters, and then press Enter.
3. Enter 3 for Change IP Address, and then press Enter.
4. From the Modify SP IP menu, enter a new IP address, and then press Enter.
5. The SP Network submenu appears, and the new IP address appears to the right of the current
IP address. Enter A, and then press Enter to quit, save, and activate the new IP address.
Changing the SP Netmask
To change the SP netmask by using SPOCC:
1.
On the SPOCC home page, click the SPmaint tab.
2. Click Network Configuration.
3. Click Change Public Network Interface Parameters.
4. Enter a new netmask in the Netmask field, and then click Save and Activate.
To change the Service Processor netmask by using SPMAINT, enter the following menu options
from the SPMAINT main menu:
1.
From the SPMAINT main menu, enter 2 for Network Configuration, and then press Enter.
22 Network Configuration