4 network configuration, Configuring the network for the service processor, Configuring the firewall – HP 3PAR Service Processors User Manual
Page 21: Displaying firewall status, Disabling permissive mode
4 Network Configuration
Configuring the Network for the Service Processor
The SP Network submenu of the SPMAINT utility allows you to manage the network and dialup
settings for the SP.
NOTE:
Modem support is available only for systems that are earlier than SP 4.1.0.
To access the SP Network submenu:
Procedure 1
1.
Log in to the SP as the spvar or 3parcust user.
2.
Enter 2 for Network Configuration, and then press Enter.
3.
Enter 4 for Change Public Network Interface Parameters, and then press Enter.
The current values are displayed along the right column. As you edit the values displayed in this
menu, the new values appear to the right of the current values. Modifications made with this
submenu are not permanent until you save or activate them from this menu by using menu option
A. The modifications are not retained if you exit this menu without saving or activating them.
Configuring the Firewall
The SP Control FW (Firewall) submenu allows you to display and alter the status of the SP resident
firewall.
Displaying Firewall Status
To access the SP firewall control options through SPOCC:
1.
Log in to SPOCC as the 3parcust user.
2.
On the SPOCC home page, in the left navigation pane, click SPmaint.
3.
Click Network Configuration.
4.
Click Firewall Manipulation.
5.
Configure the firewall options.
To access the SP Control firewall submenu in SPMAINT, select the following menu options from
the SPMAINT main menu:
1.
Enter 2 for Network Configuration, and then press Enter.
2.
Enter 3 for Firewall Manipulation, and then press Enter.
3.
Enter 1 for Display Firewall Status, and then press Enter.
Disabling Permissive Mode
By default, Permissive mode is enabled for the firewall. For increased security, you can disable
Permissive mode by using either SPMAINT or SPOCC. If you do this, you must first add at least
one host to the firewall to access SPMAINT or SPOCC.
NOTE:
Only the 3parcust user can change firewall rules in Secure Network Mode.
To disable Permissive mode by using SPMAINT:
1.
On the SPMAINT home page, enter 2 for Network Configuration.
2.
Enter 3 for Firewall Manipulation.
3.
Enter 6 for Toggle Permissive Public Firewall (currently On).
To disable Permissive mode by using SPOCC:
1.
Log in to SPOCC by using the 3parcust user account.
2.
In the left navigation pane, click SPMaint.
Configuring the Network for the Service Processor
21