Boonton 4240 RF Power Meter - Manual (Page 106)

Boonton 4240 Series RF Power Meter
Table 5-3. HP 437B EMULATION GPIB COMMANDS
Code Description Comments
SM Status message NOT SUPPORTED
SN0 - SN9 Enter sensor serial number 2 NOT SUPPORTED
NOT SUPPORTED
3
quest mask query 3
1 1 - 10
e
NOT SUPPORTED
SP - N0P SPECIAL
*SRE Set the service request mask
*SRE? Service re
ST STORE
*STB? Read the status byte
TR0 Trigger hold
TR1 Trigger immediat
TR2 Trigger with delay
TR3 Trigger-free run
3 *TST? Self test query
UP Up arrow key
ZE ZERO
@1 Set the service request mask
@2 Learn mode prefix
% Percent
1 A numeric entry is required by these GPIB codes, followed by the code EN (ENTER).
his GPIB code uses the n rscore) as input data.
ring.
2 T ext 6 characters (0 - 9, A - Z, or an unde
3 The * must be included as part of the GPIB command st
4 Offset value is always applied. Set the offset value to 0 dB for off condition. Any other value the offset is on.
Remote Operation
5-46