Boonton 4240 RF Power Meter - Manual (Page 99)

Boonton 4240 Series RF Power Meter
Table 5-1. SCPI COMMAND SUMMARY (continued)
DISPlay:Label:TEXTC
Displays a text message in the third label field.
<alphanumeric value> = A to Z, a to z, 0 to 9 ! @ # $ % ^ & *
[ ] ? / < > : .
bel field.
<alphanumeric value> = A to Z, a to z, 0 to 9 ! @ # $ % ^ & *
] ? / < > : .
ETCh[1|2]:CW:POWer? Return current average reading in power units
ETCh:KEY? Return code of last key depressed
INITiate:CONTinuous ch triggers meas cycles continuously.
<Boolean> = 0, 1, OFF, ON
INITiate[:IMMediate[:ALL]] ent cycle when trigger event
occurs
EASure[1|2]:POWer?
volts.
EMory[1|2]:SNSR:CF? Return the sensor frequency cal-factor table.
EMory[1|2]:SNSR:CWRG?
EMory[1|2]:SNSR:INFO? Return the sensor ID and parameter data.
EMory:SYST:LOAD etup by filename.
<character data> = "USER0" ... "USER10".
EMory:SYST:STORe
<character data> = "USER1" ... "USER10".
UTPut:LEVel[:POWer] evel of the internal 50 MHz calibrator
output signal.
UTPut:SIGNal Set or return the on/off state of the internal 50 MHz output signal.
UTPut:RECorder:FORCe Command sets the Recorder Output voltage to the argument.
um, or full scale (+10.0V)
power reference level.
OUTPut:RECorder:MIN t minimum, or downscale (0.0V)
power reference level
OUTPut:RECorder:SOURce for the Recorder Output.
character data> = CH1, CH2, ACTIVE
READ[1|2]:CW:POWer? power units.
( ) _ - + = { }
DISPlay:Label:TEXTD
Displays a text message in the fourth la
( ) _ - + = { } [
F
F
Set/return state of mode whi
Set mode which starts a measurem
M
Return the average power measurement in dBm
MEASure[1|2]:VOLTage?
Return the average power measurement in equivalent
M
M
Return sensor AC cal data.
M
M
Load saved instrument s
M
Save instrument setup by filename.
O
Set or return the power l
O
O
<numeric value> = 0.0 to + 10.0 V
OUTPut:RECorder:MAX
Set or return the Recorder Output maxim
Set or return the Recorder Outpu
Set or return the source channel
<
Return new average reading in
Remote Operation
5-39