Boonton 4240 RF Power Meter - Manual (Page 126)

Boonton 4240 Series RF Power Meter
NO. MESSAGE DESCRIPTION
sor Disconnected."
-249 "FPGA download err"
63 “MFS Init”
64 “Flash init”
66 “Mem restore”
80 “Program error”
95 "Command not in language."
96 "Data out of range, set to limit."
97 "Command not supported."
13 “Cal mem lost”
40 “Calibration failed”
50 "Error queue overflow"
60 “Communication Error”
62 “Snsr2 Pag
-363
“Snsr1 Pa
-
364 “Sensor access fault”
71 "Err CH2 Sensor Data" Checksum failure of the Channel 2 sensor EEPROM.
72 "Err CH1 Sensor Data" Checksum failure of the Channel 1 sensor EEPROM .
73 “Measurement Error”
75 "Cmd not accepted"
76 "I2C Timeout" Software has timed-out while communicating over the I2C bus.
77 "No I2C Ack" Missing Acknowledge signal while assessing the I2C bus.
97 "Err CW signal."
-245 "Sen
-246 “Sensor voltage error”
-247
"No Calibrator" The calibrator is not responding to instrument control.
-248 "Keyboard error"
-2
-2
-2
-2
-2
-2
-2
-3
-3
-3
-3
-3 e Blank”
ge Blank”
-3
-3
-3
-3
-3
-3
-3
Appendix A
8-2