Boonton 4240 RF Power Meter - Manual (Page 32)

Boonton 4240 Series RF Power Meter
3-5. Mod nd Set
ast Menu Operatio ey stokes to perform a function repeat d , the control program can
ing to t . In doing be
ser bac play faste
g the internal calibrato e output level needs to be
, the CALIBRATOR LEVEL function is selected.
ccomplished b (assuming is already O enu> – <Down Arrow>
o CALIBRA ter> f the desired press <Enter> to set
e calibrator to that lev
ow pressing the <Me ent to the measurement display. To change the level simply pressing the
LEVEL function.
mple two k ich may but if many are needed to be tested,
submenu, th <Up Arro RTN or escape to the
nu using the out creen by th , pressing the <Menu>
ey will bring up the to
Figure el 4240, Comma
L n. In keeping with minimum e ly k
remember the last menu the user was at prior to return he measurement display this submenu functions can
uickly selected and parameters changed getting the u k to the measurement dis r. q
sin r. Th For example, suppose the user wants to check the sensors linearity u
hanged repeatedly recording the measurement results at each level. First c
This is a
y the following key presses the Calibrator Signal n); <M
to point t ble the setting o level then ( TOR) – <Enter> –Next press <En to ena
th el.
rum N nu> key will return the inst
<Menu> key returns the instrument to the CALIBRATOR
In this exa
ey strokes are eliminated wh not seem like a lot levels
remembering the last menu will save a lot time.
Once in a
e previous menu can always be reached by depressing the w> until
arent me user exits to the measurement s is method p <Left Arrow> key. If the
k p level menu.
Getting Started
3-8