6 initiate and abort commands, Abort, Initiate:continuous – Boonton 4240 RF Power Meter User Manual

Page 78: Initiate[:immediate[:all, 6 initiate and abort commands -18, Abort -18, Initiate:continuous -18, Initiate[:immediate[:all]] -18, Boonton 4240 series rf power meter, Remote operation 5-18

Advertising
background image

Boonton 4240 Series RF Power Meter

5.5.6 INITiate and ABORt Commands

tion in progress and prepares

e instrument for an INITiate command.

BORt

on:

nt in progress and resets the state of the trigger system. Note that

the measurement in a stopped condition with all current measurements cleared,

and forces INITiate:CONTinuous to OFF.

Syntax: ABORt

one

ITiate

uous

Description:

Set or return the data acquisition mode for single or free-run measurements. If
INITiate:CONTinuous

is set to ON, the 4240 immediately begins taking measurements. If set to

OFF, the measurement will begin as soon as the INITiate command is issued, and will stop once

e measurement criteria (averaging, filtering or sample count) has been satisfied. Note that

and READ commands are invalid when INITiate:CONTinuous is set to

does not result in a SCPI error.

>

0, 1, OFF, ON }

ITiate[:IMMediate[:ALL]]

Description:

Starts a single measurement cycle when INITiate:CONTinuous is set to OFF. The measurement

ILTer time. No reading will be

mplete. This command is not valid when

ever, by convention this situation does not result in a SCPI

:IMMediate[:ALL]]

Argument:

None

INITiate:CONTinuous

must be OFF

The purpose of the INITiate group of commands is to start and control the process of data acquisition once a measurement
has been configured. Depending on settings, the 4240 RF Power Meter may be commanded to begin either a single
measurement (INITiate:CONTinuous OFF) which stops when complete, or enter a “free-run” mode where data acquisition
occurs continuously (INITiate:CONTinuous ON). The ABORt command terminates any opera
th


A

Descripti

Terminates

any

measureme

ABORt

will leave

Argument:

N

IN

:CONTin


th
INITiate:IMMediate
ON; however, by convention this situation

Syntax: INITiate:CONTinuous

<Boolean

Argument:

<Boolean> = {

IN

will complete once the power has been integrated for the full F
returned until the measurement is co
INITiate:CONTinuous

is ON, how

error.

Syntax: INITiate[

Restrictions:

Remote Operation

5-18

Advertising