Boonton 4240 RF Power Meter - Manual (Page 71)

Boonton 4240 Series RF Power Meter
CALCulate:LIMit:UPPer[:POWer]
Description: Set or return the upper limit power level for the selected channel. This limit is used for level
alue and flag bits are set in the alarm register which may
? query and CALCulate:LIMit:CLEAR commands.
2]:LIMit:UPPer[:POWer] <numeric value>
Argument: <numeric value> = -99.99 to +99.99 dBm
ALCulate:LIMit:LOWer:STATe
escription: annel. When the lower alarm is
to the preset lower power limit, and the
rs if the power is out of range.
n>
Argument: <Boolean> = { 0, 1, OFF, ON }
ALCu
escription: is
the
n OFF, no action occurs if the power is out of range.
OTH]:STATe
if out of range. When OFF, no action occurs if the power
it alarm is enabled. A query
Argument: <Boolean> = { 0, 1, OFF, ON }
alarms. When the measured average power is above the upper limit, an up arrow ▲ will appear on
the display to the left of the measured v
be accessed using CALCulate:LIMit:FAIL
Syntax: CALCulate[1|
C
D Set or return the lower limit alarm system state for the selected ch
enabled (ON), the measured average power is compared
error flag is set if out of range. When OFF, no action occu
Syntax: CALCulate[1|2]:LIMit:LOWer:STATe <Boolea
C late:LIMit:UPPer:STATe
D Set or return the upper limit alarm system state for the selected channel. When the upper alarm
enabled (ON), the measured average power is compared to the preset upper power limit, and
error flag is set if out of range. Whe
Syntax: CALCulate[1|2]:LIMit:UPPer:STATe <Boolean>
Argument: <Boolean> = { 0, 1, OFF, ON }
C
ALCulate:LIMit[:B
Description: Set or return the combined upper and lower limit alarm system state for the selected channel.
When alarms are enabled (ON), the measured average power is compared to the preset upper and
lower limits, and the error flags are set
is out of range. A query returns 1 if either the upper or lower lim
forces both upper and lower ON if either is enabled.
Syntax: CALCulate[1|2]:LIMit:[BOTH]:STATe <Boolean>
Remote Operation
5-11