JKS 2002 - Manual

JKS2000 / JKS2001 / JKS2002 JKS Quicker Disconnect Installation Page 1
Product: Quicker Disconnects™
Part Number: JKS2000 - JKS2001 - JKS2002
INSTALLATION
INSTRUCTIONS
Welcome
CONGRATULATIONS on purchasing a set of new
Quicker Disconnects™ from JKS Manufacturing. We
are committed to providing you with the best products
available and your satisfaction is our first priority.
PLEASE READ these Installation Instructions careful-
ly, and save them for future reference, as they contain
important installation and maintenance information.
Important
NOT COMPATIBLE WITH aftermarket swaybars. Install
product with Original Equipment swaybar only.
SOME VEHICLES MAY REQUIRE extended front brake
hoses or other modifications to compensate for ad-
ditional suspension travel.
NEVER DISCONNECT swaybar when operating vehicle
on public roads.
WHEN DISCONNECTED, swaybar must be secured to
prevent interference with other suspension compo-
nents or axle.
Tools Required
 Metric/Standard Socket Wrench Set
 (17mm and 3/4” sockets)
 Torque Wrench
 Tie Rod End Remover *
 6mm Allen Head Socket
 6mm Allen Wrench
 1/4" Allen Wrench *
 15/16” Open-End Wrench
 #1 Philips Screwdriver or Small Punch
 F” Drill Bit (0.257” equiv.) *
 5/16” x 18TPI Tap *
 Angle Measuring Tool
 Grease Gun with Zerk Fitting Coupler
 Wheel Bearing Grease
* Asterisk denotes tools that are not required for some applica-
tions. Thoroughly read instructions first to determine which tools
will be required for your application.
517-278-1226 • [email protected] • www.jksmfg.com
491 W. Garfield Avenue, Coldwater, MI 49036