JKS 2002 - Manual (Page 5)

JKS2000 / JKS2001 / JKS2002 JKS Quicker Disconnect Installation Page 5
‰ 7. LUBRICATE QUICKER DISCONNECTS
 Lubricate all Grease Zerk fittings (J) on the Quick-
er Disconnects immediately after installation using
common wheel bearing grease or equivalent.
Troubleshooting
If swaybar does not rotate freely, remove from vehicle,
clean and apply rubber lubricant to chassis-mounted
bushings, and reinstall.
Contact between Quicker Disconnect U-Strap (A)
and vehicle chassis on Wrangler TJ models usually
indicates a misaligned swaybar caused by a front axle
that is not centered. Take consistent measurements
on each side of vehicle to confirm misalignment, and
install JKS Adjustable Trackbar (available separately)
to correct.
Maintenance
It is important to lubricate Quicker Disconnects fre-
quently for the first three (3) months after installation
to evacuate contaminants that may build up during
break-in period.
After break-in period, Quicker Disconnects should be
lubricated regularly as part of vehicle maintenance
schedule.
Regular cleaning with pressurized water is recom-
mended to maximize ease of operation and reliability.
Always lubricate afterwards to evacuate any moisture.
©2013 JKS Manufacturing, Inc & Aftermarketing, LLC
Revision Date 9/30/2013