Parts, Installation – JKS 2002 User Manual
Page 2
JKS2000 / JKS2001 / JKS2002
JKS Quicker Disconnect Installation
2 Page
Parts
A
U-Strap
B
10mm x 35mm Button Head Bolt
C
10mm Nylock Nut
D
10mm x 50mm Button Head Bolt (with factory-applied
thread locking compound)
E
1.25” Aluminum Sleeve
F
Stainless Steel Post
G
Spherical Bushing
H
Click Pin
I
Grease Zerk Cap
J
Press-In Grease Zerk
K
1/2” NF Nylock Nut
L
Offset Polyurethane Spacer
M
5/8” Jam Nut
N
Upper Male Threaded End
O
Lower Female Threaded End
P
Flat Washer
Q
Storage Pin
R
5/16” x 1-1/2” NC Allen Bolt
S
10mm External Tooth Lock Washer
Installation
1. REMOVE ORIGINAL EQUIPMENT (OE)
SWAYBAR LINKS\
Remove front swaybar drop links and mounting
hardware per the factory service manual instruc-
tions for your vehicle.
HINT: If difficult to remove,
use special factory removal tool PN MB991113
(Miller Special Tools, 800-801-5420) or similar tie
rod end removal tool.
2. INSTALL UPPER U-STRAPS
Mount U-Strap (A) on top of swaybar with thread-
ed leg of U-Strap positioned inboard.
IMPORTANT: U-Strap must be mounted ABOVE
swaybar, NOT BELOW
Insert 10mm x 35mm Button Head Bolt (B) and
Flat Washer (P) – only if required – upward
through swaybar and U-Strap (A). Secure with
10mm Nylock Nut (C).