JKS 2002 User Manual
Page 3
JKS2000 / JKS2001 / JKS2002
JKS Quicker Disconnect Installation
Page 3
IMPORTANT: Flat Washers are supplied for use
with 1984-01 Cherokee XJ and 1993-98 Grand
Cherokee ZJ models ONLY. Do NOT use Flat
Washer on Wrangler TJ models.
Tighten 10mm Nylock Nut (C) to 40 ft-lb. using a
torque wrench.
3. INSTALL LOWER TAPERED POST
Insert Stainless Steel Posts (F) into the lower
swaybar link holes on the front axle. Position posts
with tapered ends pointing inboard, ensuring small
Click Pin holes are horizontal or parallel with the
ground.
Install 1/2" Nylock Nut (K) on outboard side of
lower swaybar link brackets and tighten to 65 ft-lb.
using a torque wrench.
HINT: A small Philips head screwdriver or punch
inserted into the Click Pin hole will enable you to pre-
vent the tapered Stainless Steel Posts from rotating
when tightening the Nylock nut.
4. SET QUICKER DISCONNECT LENGTH
Determine the Ideal Swaybar Angle for your ve-
hicle according to the following chart.
Adjust the length of your Quicker Disconnects until
swaybar is at the Ideal Angle or within Acceptable
Range. Vehicle must be at normal ride height and
located on level ground.
Once adjusted, lay Quicker Disconnects on a flat
surface and tighten Jam Nuts (M) firmly against
the Lower Ends (O).