Remote modem setup - using hyper terminal, Remote modem setup, Host mode: remote modem setup – DAVIS FMS 3.9.3 DriveRight (8186) User Manual
Page 123
DriveRight FMS Help
Note: Because the DriveRight 500 and earlier versions of DriveRight communicate at 2400 baud
and the DriveRight 600 communicates at 19,200 baud, you must configure your computer to
communicate with either the DriveRight 600 or with earlier models.
See also:
Back to
|
Remote Modem Setup - Using Hyper Terminal
The external modem at the site where the DriveRight is connected is called the "remote" modem.
The DriveRight owner, when he wants to download his information, connects the DriveRight to
this modem using the interface box and modem adapter included in the Remote Modem Kit. He
then turns the modem on, and it will dial the host computer and the download will be initiated.
However, before the modem will dial up the host computer and download correctly it must be set
up correctly. The following instructions explain how to do this manually for a US Robotics Courier
V. Everything modem and the Windows 95 accessory program Hyper Terminal. In addition, the
setups for US Robotics 56K Fax Ext are included.
Unfortunately, not all modems have the same command set or act the same way on power up. If
you are using a modem other than the one described, read the instructions below and then refer
to your specific modem documentation to determine if your modem can be used.
Note: When you are asked to type a command, do not type the quotes. Type all commands in
upper case.
111